-
Jul 27,2020
Problems and solutions of Spindleless Wood Veneer Machine 1 Problem 1 -Uneven wood veneer Causes: 1. Poor knife straightness 2. Decentraction ( not properly aligned) between shaft ends and body 3. Excessive squeezing force 4. Serious wood sunny side and shadow side 5. Too small and not straight wood log Solvi...
View More
-
Aug 7,2020
Problem: Uneven thickness of veneer peeled by wood veneer machine Reason: 1. The knife position is incorrect. 2. The knife is not sharp enough. 3. The knife gate gap is too small or too large. 4. The wood is too dry or too hard. 5. The carbon brushes of the electromagnetic clutch are virtually connected. 6.&n...
View More
-
Sep 11,2020
Problems and solutions of Spindleless Wood Veneer Machine 3 Problem: The wod veneer is periodically uneven. Reason: The sunny and shadow surfaces of the wood veneer are too heavy; the peeling knife of veneer lathe/veneer machine is too low or too high, and the clearance between the single and double roller bearings is too large. Solutions: Correctly adjust the height o...
View More
-
Sep 22,2020
Problem: 1.The end of the wood veneer is thinner than others peeled by wood veneer lathe. 2.The end of the wood veneer is thick and curled. Reason: The peeling knife is too low or too high and the knife gap is small or too large, and the knife position needs to be adjusted.
View More
-
Oct 28,2020
Problems and solutions of Spindleless Wood Veneer Machine 5 Problem: The thickness of the two ends of the remaining wooden shaft is inconsistent, and the wood veneer surface is fan-shaped. Causes: 1.The height of the two ends of the veneer peeling knife is inconsistent; 2. the gap between the two ends of the knife is inconsistent; 3. the single roller bearing is damaged; 4. the screws are lo...
View More
-
Jun 16,2020
Veneer is a thin sheet of wood either sliced or peeled from a log or flitch. There is Grade A, Grade B and Grade C wood veneer. A Grade-The veneershall be smooth,tight cut and full length. This grade of wood veneer can be used as the face veneer in plywood. B Grade-The veneer's open defects such as knots,holes or splits are filled. This grade of veneer will be used as the core veneer. Wood veneer ...
View More
-
May 11,2020
Improper hoisting will influence the structure of the Wood veneer machine. The machine structure is important to make smooth, good quality veneer. There is four holes for hoist in the side of the machines. Please place some short logs beside the holes for hoist to avoid the damage during hoisting.
View More
-
Apr 28,2020
The Spindleless veneer peeling machine is a veneer lathe under a spindleless condition that includes the veneer knife and at least three rollers. Feeding mechanisms couples to two feeding rollers and a drive system couples to one of the driving rollers. The wood log will driven by three rollers and being peeled to veneer.The veneer thickness can be changed by adjusting the gap between single rolle...
View More
-
Jan 16,2020
All kinds of Veneer Peeling machine and Plywood machines will have middle or heavy wear after long time service. Let's try to figure out the reason. 1. The un-even of both ends and body of wood log will hurt the peeling roller and make the peeling discontinuously and peeling knife go blunt. 2. Use the veneer making machines continuously and without any maintenance and cleaning. 3. The workers oper...
View More
